Basic Steps on How to Replace a Window
It is important to learn how to replace a window to remodel a house. Doors and windows are commonly replaced to maintain a new looking house or structure.
People can choose to learn on how to replace a window themselves because of several factors such as broken or damaged windows and old windows.
They may also choose to upgrade their windows to double glazed, triple glazed or just to have a better energy efficiency rating. Whatever the reason is, a homeowner would have to learn from the following steps on how to replace a window.
How To Replace A Window
How to Replace A Window By Yourself Tips
Here are the simple guidelines on how to replace a window:
Measure the new replacement window. This is the primary step on how to replace a window. The measurement for the height and width of the new window is important. Measure the sill from top to bottom to get the height. To get the width from one side of the window to the other side, the jamb should be measured from the inside to the other side.
The second step on how to replace a window is to remove all the visible nails and screws. Nails and screws might be covered with paint. Use a utility knife to cut all the screws on the window for it to loosen up. Screws and the window may be a little tedious to remove and sometimes a pry bar is needed to work the sills and the outer jamb free.
Lift the window. In order to lift the window carefully into place, another person must go inside the house to hold the window in place while the other one is lifting it.
Determine if the window is level. This is one of the important steps on how to replace a window. Use the shingle shims to make the window level on both sides.
Another person should be on the inside of the house to hold the window while placing the shims in the right place while the person outside holds the level. The person on the outside dictates the other person how much the window is needed to be moved.
Using a tape measure, measure the window from corner to corner doing the cross pattern on both sides. Both sides should have equal measurement.
Place screws in each drill hole and hit as many shims so they will not be moved and they will be kept in place.
Check everything again. This step is a must on how to replace a window. Recheck and make sure that the window is level and all screws are positioned correctly in their right place. Check if the window is still and doesn’t move.
The final step on how to replace a window is to fill all the cracks visible by spraying non-expanding foam on it. Seal the outer frame by putting silicon around it.
Those are simple steps on how to replace a window. Whatever type of window is going to be replaced, doing basic steps will help homeowners to remove and install a new window again easily.
It might be a tedious task to learn how to replace a window. However, there are immediate sources that can provide a step-by-step instruction on how to replace a window.
Homeowners can almost learn how to replace a window themselves without further asking assistance from window manufacturers. Not only does it save them money, but it lets them enjoy the new learning they have on how to replace a window.
Read also: Milgard Windows
Page: How To Replace A Window
